• Dredging Depth. 20 feet standard (up to 40 feet optional)
  
• Cubic yards of sludge processed per hour. Up to 150 cubic yards
  
• Discharge volume. 2,500 gallons per minute @ 80' TDH (water)
  
• Dredging Speed. Up to 19 feet per minute
  
• Width of dredging Cut. Up to 7.5 feet
  
• Cutterhead Torque. Up to 11,000 inch/lbs.
  
• Draft. 27 inches
  
• Maximum floating discharge distance from Rotomite. 3000 feet plus
  

Crisafulli's unique steerable variable speed hydraulically powered propulsion system provides approximately 1,000 pounds of thrust enabling the Rotomite-6000 and its Crisafulli 6" discharge J-Series pump to dredge and process up to 150 cubic yards of sludge and slurries per hour at depths up to 20 feet (standard; deeper in custom models) in a wide range of applications without the cost and delays of a cabled traverse system. Should the operator desire to use a traverse system rather than the Rotomite's self-propulsion feature, Crisafulli's patented Pivoting Traverse System^TM enables the Rotomite operator to turn the dredge 180 degrees in minutes at the end of each pass without disengaging the cabling system - thereby eliminating down-time and improving productivity up to 48%.

Great visibility. Note the Operator's clear view of dredging operations from the forward positioned cab with large windows on all four sides shown above on the Rotomite-6000. The new cab (with optional air and heat) is accessible from either side of the dredge for improved convenience, productivity, and safety. Stern view. The clean lines of the steerable propulsion system and discharge pipe can be seen in the center shot. Note too, the lifting crane positioned to facilitate removing the propulsion system above the water for inspection and maintenance. Cobra Cutterhead. Observe the unique opposing augers of the cutterhead designed to drive dredged material towards the center of the cutterhead and directly in front of the pump intake for maximum capture of solids, highest efficiency and reduced turbidity. Fully articulating, the cutterhead can be rotated 84 degrees on the Rotomite-6000 and 70 degrees on the Rotomite-8000 to attack compacted, settled wastes. Safety guard rails. Note the guard rails on each side of the dredge and flanking the ladder.